This user guide provides step-by-step instructions on how to use this design in addition to things that one must refrain from doing with this design.

Setup / How to Wear

The wearable accessory will be enclosed in a case that should not be opened. In most situations, all necessary components that the user needs to interact with are located outside of the case.

1. Attach the case to the armband
2. Locate the heart rate monitor, which consists of three (3) electrodes of black, red, and blue colors. Place the electrodes in either configuration as shown in the diagram: Note: with rare exceptions, the human heart is located on the left side of the body

1. Locate the skin conductivity sensor, which consists of two hanging wires. Using tape, attach them to opposite sides of the wrist
2. Locate the microphone, which is a small circular component. Using tape, attach it as close as possible to the mouth of the user to maximize audio capture and accuracy
3. After securing all components, attach the armband to the user’s arm

Basic Operations

Panic Attack Toggle: The device will automatically detect when a panic attack occurs. The panic attack state can also be toggled on/off manually by pressing a blue button located on the microcontroller inside of the case. In the event of a falsely detected panic attack, the user should open the case and press the button.

Modules for Panic Attack Detection: Several components are used to detect panic attacks

• The omnidirectional microphone monitors the breathing rate of the user
• The heart rate monitor monitors the heart rate of the user
• The skin conductivity wires monitor the skin conductivity of the user

Modules for Panic Attack Mitigation: Several components are used to calm the user down during a panic attack

• The speaker plays calming audio
• The LED light emits calming blue light
• The LCD display generates helpful and calming text

Advanced Features